|
Battery supply: The Cruise 2.0 R requires a
battery voltage of 24 V. It can be powered by a Power
26-104. In this case, the battery bank weighs only 55 lbs.
Alternatively, it can be powered by at least 2 lead-gel or
AGM batteries. In this case, we recommend a battery capacity
of at least 180 Ah. Because lead-gel and AGM batteries can’t
supply higher currents very well, the battery bank capacity
should have several reserves ready.
The Cruise 4.0 R
requires a battery voltage of 48 V. It can be powered by two
Power 26-104. In this case, the battery bank weighs only 110
lbs. Alternatively, it can be powered by at least 4 lead-gel
or AGM batteries. In this case,
Torqeedo recommends a battery
capacity of at least 180 Ah for the reasons given above.
The Twin Cruise 2.0 R requires a battery voltage of 2 x
24 V. (24 V for each motor), i.e. two Power 26-104 (one
battery per outboard). In this case, the battery bank weighs
approx. 110 lbs. Alternatively, it can be powered by at
least 4 lead-gel or AGM batteries. In this case,
Torqeedo
recommends a battery capacity of at least 180 Ah (for each
motor).
The Twin Cruise 4.0 R
equires a battery voltage of 2 x 48
V. (48 V for each motor). It can be powered by four Power
26-104 (2 for each outboard). In this case, the battery bank
weighs approx. 220 lbs. Alternatively, it can be powered by
at least 8 lead-gel or AGM batteries – which weigh, however,
1,058 lbs.
On-board computer, all Cruise R models:
The on-board computer integrated in the throttle analyzes
and combines information from the motor, batteries and the
GPS. The motor consumption and GPS speed data are always
precise. The battery information is equally precise when the
Cruise is powered by the Power 26-104 because both products
communicate with each other. If the Cruise is powered by
other batteries, the battery charge and remaining range
indicators rely on estimates derived from the battery
information entered in the system’s set-up menu during
initial installation.
Twin Cruise installation: A Twin Cruise
outboard system consists of two Standard Cruise models (2.0
R or 4.0 R) as well as the Twin Cruise Control Set, which
consists of a dual throttle and a connection bar for linking
two Cruise outboards to the same standard steering system.
Standard installation with the Twin Cruise Control Set
requires minimum transom width of 30 inches (the length of
the tie bar for connecting two motors is 22 inches and
included in delivery).
Limited warranty: 2 years | 
